School: Lurga, Patrick's Well (roll number 10317)

On this page

1. Candle-Making in the District in Former Times

   

   Share Share Post

   

   You are not logged in, but you are welcome to contribute a transcription anonymously. In this case, your IP address will be stored in the interest of quality control.

   Candle Making in This District in Former times. In olden times when lamps or was candles were scarce, the inhabitants of this district used to get bulrushes from the bogs and make what was known as "Rush candles". when the bulrushes were gathered, one of the members of each house was set at the task of peeling them. When the rushes were peeled, the white thing that remained was put into a pan of hot grease. After a few minutes the rushed would be taken up from the pan, and put into a wooden candlestick and lit. those candles used to be renewed very often because they would not last long. Recorded from Ml. McGrath at a later period.

   Save Cancel

   Transcription guide »

   By clicking the save button you agree that your contribution will be available under the Creative Commons Attribution-NonCommercial 4.0 International License and that a link to dúchas.ie is sufficient as attribution.

   Topics

   1. activities
      1. economic activities
         1. trades and crafts (~4,680)
            1. candle-making (~728)

   Language

   English

   Informant

   Ml. Mc Grath

   Gender

   Male

   Address

   Ballycarney, Co. Limerick

2. Candle-Making at a Later Period

   

   Share Share Post

   Candle Making at a Later Period.

   
   In olden times in Ireland the old people used to make their own candles. In order to make those candles they used to get oval shaped metal vessels. Each vessel had three legs on it and a long handle. This vessel was known as a "Griosad". Then they got the fat from a cow or sheep and put it into the "Griosad" over the fire. Then they got a long flat board with four or five round holes in it. They had moulds in which they used to make the candles, they used to drop the mould through the holes in the board.

   The tops of the moulds were wider in the top than the bottom and this prevented the mould from slipping all the way through the holes. The wick was then got and twisted around a nail. The end of the wick was allowed to drop into the mould and the nail was put across the top of the mould.

   (continues on next page)

   

   Transcribed by a member of our volunteer transcription project.

   History Edit